How to fix a dripping tap in about half an hour

A dripping tap is easy to ignore, but a steady drip can waste thousands of litres of water over a year, and on a hot tap you are paying to heat it too. The good news is that the cause is usually one small, cheap part.

First, know which kind of tap you have

Most household taps fall into two groups:

  • Compression taps have separate hot and cold handles that you turn several times to open fully. They seal with a rubber washer, which wears out.
  • Quarter-turn and mixer taps open with a short turn or a single lever. Inside is a cartridge, often with ceramic discs, and the usual culprits are its seals or the cartridge itself.

What you need

  • An adjustable spanner
  • A flat and a cross-head screwdriver
  • A cloth or towel
  • The replacement washer or cartridge (take the old one to a hardware shop to match it)

Step by step

  1. Turn off the water. Look for the small isolation valve on the pipe under the sink and turn its slot a quarter turn with a screwdriver. If there is none, turn off the main stopcock. Open the tap to drain what is left in the pipe.
  2. Put the plug in. A small screw dropped down the drain will ruin your afternoon.
  3. Remove the handle. There is usually a decorative cap on top. Prise it off gently and undo the screw underneath, then lift off the handle.
  4. Undo the body. Use the spanner on the large nut to unscrew the headgear or cartridge. Wrap the cloth around chrome parts to avoid scratching them.
  5. Swap the worn part. On a compression tap, the washer sits at the bottom, held by a small nut or just pressed on. Replace it with the new one. On a cartridge tap, fit the new cartridge in the same orientation as the old one.
  6. Reassemble in reverse order. Tighten firmly, but do not force anything.
  7. Turn the water back on slowly and check for drips.

If it still drips

  • The seat that the washer presses against may be scratched or worn. A plumber can regrind it, or a seat repair kit can help.
  • Water coming from around the handle, rather than the spout, usually means a worn O-ring on the spindle, which is another cheap fix.
  • If the tap is very old, or parts are hard to find, replacing the whole tap may be simpler.

When to call a plumber

If you cannot find a way to turn off the water, if nuts are badly corroded, or if there is any leak under the sink rather than at the tap, it is worth calling a professional. For a simple drip, though, half an hour and a small part is usually all it takes.